Laser Christmas decorations: candle arch, plug-in stars, fir trees & light houses

Laser Christmas decorations: candle arch, plug-in stars, fir trees & light houses

Your plywood sheet says 3 mm, but the calipers say 3.2. With most laser files, that means the stars jam, the tabs snap when you press them in, and half the sheet ends up in the wood stove. Here you get five coordinated Christmas projects, from a glowing arch of lights to a place card with a name, and each one is calculated individually for 3, 4, and 6 mm wood and 3 mm acrylic. A test comb shows you in advance which slot fits, and the included generator converts everything to your measured thickness.

  • Recalculated rather than scaled: slots, tabs, and finger joints are specially drawn for each material thickness, which is why the light arch stays about 286 mm wide even when made from 6 mm wood.
  • For your board: cut a test comb, read off the matching slot, and the Passt-genau generator creates all the parts offline in the browser for your measured thickness, kerf, and work area.
  • Ready to go right away: All parts are already laid out on sheets for 300 × 200 and 400 × 400 mm, as SVG, DXF and PDF at 1:1, with red for cutting, blue for scoring and black for engraving.
  • For each project there is a German-language building guide with a parts overview, assembly in rendered steps, and tips on lighting, surface finish, and safety.
  • Personalized gifts: Type a list of names into the generator, and every place card and every tag gets its name as a finished engraving.

Measure, cut a test comb, start lasering: Your Christmas decorations will fit, no matter which board happens to be on the shelf.

content

5 items

Light decoration

3D plug-in decoration

Pendants & Place Cards

Comments (0)

Comment now „Laser Christmas decorations: candle arch, plug-in stars, fir trees & light houses“