The sun is just breaking through a gap in the canopy and hitting the bodywork of your car exactly. Moments like this are over quickly, and setting up a tripod takes time that you don't have. In this tutorial, the instructor shows you how to shoot handheld by changing only a few camera settings. That way you capture the light before it disappears.
Key Takeaways
- A tripod is not strictly necessary. With a shorter exposure time, handheld shots can also come out sharp.
- You determine aperture and ISO together: a slightly smaller f-number and a slightly increased ISO value shorten the exposure time.
- A polarizing filter removes distracting reflections on the bodywork and makes the colors look more vivid.
- Your position relative to the sun determines the mood. Even one or two steps to the side can make the difference.
- With a test shot, you check exposure and composition before you continue shooting.
Step-by-Step Guide
Step 1: Find the Right Location
First, look for a place where the sunlight falls directly through the trees. A narrow gap in the forest is ideal because it creates a clear cone of light. Walk around a few steps and observe where the light hits the vehicle. You don't have to search for long; often the best spot is only two or three steps from your first position.

Step 2: Leave the Tripod Alone
Don't put the camera on the tripod, but hold it in your hands. The advantage lies in mobility: you can react immediately when the light changes and don't have to realign every time. Hold the camera steady and brace your elbows against your body so that the shot stays stable.

Step 3: Adjust the Perspective to the Sun
Now go a bit back toward the ground until the sun becomes visible in the image and at the same time the car is well lit. Make sure that the ray of light is not only behind the vehicle, but hits it from the side or at an angle from the front if possible. This creates a mix of light and shadow that gives the image depth.

Step 4: Switch to Automatic
Set your camera to automatic mode. This setting helps you shoot quickly while the camera basically takes over the exposure. However, you keep control over the aperture and the ISO value, which you adjust specifically in the next step.

Step 5: Coordinate Aperture and ISO for Shorter Exposure Times
Now change the aperture a little by correcting the aperture value slightly downward, that is, to a smaller number. This lets more light fall on the sensor. Then increase the ISO value very slightly. Both adjustments together shorten the exposure time. This is crucial, because the shorter the time, the lower the risk that your hand blurs the image. However, don't overdo it: an ISO value that is too high produces image noise, which swallows the details of the car.

Step 6: Take a Test Shot
Now take a first test shot. Check on the display whether the image is sharp and whether the exposure is right. If the subject is too dark, open the aperture a bit more or increase the ISO value carefully. If it is too bright, reduce the values again. This short check saves you a lot of post-processing later.

Step 7: Set the Polarizing Filter
The polarizing filter is a valuable tool in the forest. Rotate it until the reflections on the side panel of the car disappear. In this shot, you should see the complete side panel without distracting reflections. Make sure you don't shift the filter while rotating it, as otherwise the effect changes. Once the effect is right, you can continue working with the subject.

Step 8: Finding the Best Spot for the Sunlight
Now move your head and camera slightly until the sunlight falls on the vehicle exactly where you want it. Sometimes a small turn or a knee bend is enough to guide the beam of light from the hood to the side panel. Feel free to try out several positions and compare the results on the display.

Step 9: Checking the Image and Evaluating the Mood
Take a calm look at the shot. The sun is slowly sinking, the light is getting warmer, and the rays are falling through the trees. This mood is exactly what makes your picture come alive. If the mood is right, you can capture the moment. While doing so, check that the background doesn't look too busy and that the car is the center of attention.

Step 10: Taking a Quick Shot for More Atmosphere
Finally, a spontaneous quick shot is worthwhile. Especially when the light briefly shines particularly intensely through the branches, there is a great chance of getting a shot with plenty of atmosphere. Shoot in quick succession during this phase, because the light changes rapidly. You will see that the spontaneous pictures are often the most vibrant.

Step 11: Wrapping Up the Session
When you are satisfied with the results, end the shoot. Save your best shots directly to the computer and compare them at your leisure. You will find that the effort was worth it, even though you worked entirely without a tripod.

Summary – Handheld Car Photography: Capturing Sunlight in the Forest
Handheld shots of cars are not a compromise, but a good method for reacting flexibly to the light. What matters is that you shorten the exposure time by deliberately adjusting aperture and ISO. With the polarizing filter you remove distracting reflections, and the right position relative to the sun creates the desired mood. Use test shots for checking, and don't hesitate to plan in spontaneous quick shots when the light is especially beautiful.
FAQ
Do I always need a tripod for car photos in the forest?No, with enough light and a short exposure time, handheld shots work out without any problem.
How do I set up the camera so the shot doesn't blur?Choose the automatic mode, open the aperture slightly, and carefully increase the ISO value so that the exposure time becomes shorter.
What do I use the polarizing filter for in car photos?The polarizing filter reduces reflections on paint and glass and makes the colors look more intense.
How can I tell whether the image is too dark or too bright?Check the display after every test shot and adjust the aperture or ISO value in small steps.
Why should I change my position relative to the sun?Even small movements change how the light falls on the body and thus influence the mood of the image.
